|Ford 9N, 2N & 8N Discussion Forum|
Re: 6V Genny Now Overcharging
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
Welp, crank been turned and new rods and mains and she's back up on her feet. No 2 main bearing spun to what I suspect was low torque on the cap. Got about 20 lbs OP cold and 10 hot, so I may rebuild the pump next time (and I hope there is no next time) :?
Went ahead and put a new bearing and bushing in the genny while I was at it and she is much happier. By sanding a little around the Vreg I got a better ground and the problem was solved.
My ammeter reads about 20 amps after startup, but falls quickly to 0 with a fully charged battery. Now I need to get the lights back on.
If it dries out, I hope to have the garden plot turned by late this week. Big thanks to everyone who hung in there with me and helped out.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters