OT - AC/DC welder progress

I wanted to post this before I button it up.

I'll post later on its operation.

Greg
a105090.jpg

a105091.jpg

a105092.jpg
 
Almost finished!
I fired it up just to check the open circuit voltage to make sure it was at 80V on the lowest current setting and about 60V on the 225A setting.
I loosely connected the AC-225 to the DC input and read the DC voltage down below after the bridge and choke.
Average DC read also read about 60V to 80V.

I got the AC-225 for the higher voltage level compared to the Craftsman with an open circuit voltage of only 45V.

I should get better results with the AC-225 when converting to DC.

Greg
a105330.jpg
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top