|BMACK518N said: (quoted from post at 14:05:48 02/20/13) Study up, more to grease zerk's than you think. Even metric sizes now.|
Sometimes the advice you get here isn't even worth what you pay for it which is zero. JC also needs to do some studying on thread/pipe sizes. The pitch diameter of a 1/4" NPT male pipe thread is .447 at the first thread (small end) of the taper. Good luck screwing that into a 1/4 tapped hole of any pitch :roll:
TOH This post was edited by TheOldHokie at 10:30:18 02/20/13.