Topic: Re: 9N oil pump bushing
|Ford 9N, 2N & 8N Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
Oilite is made with oil encapsuled into bronze. It is made to be self lubing.
The bushing material you should go for is silicon bronze. The silicon content gives it great wear qualities.
The method of installing and then reaming in a mill sounds problematic to setup square and centered.
If you use a single setup (don't unchuch and rechuck) with a lathe to machine both the inner and outer surfaces, the outside of the bush will be perfectly concentric to the inner bore. If the pump housing was manufactured correctly you should have no problems.
Mount a bar with the full length of the bushing plus 3/8 inch outside the chuck. Drill, bore, ream deeper than necessary, testing for fit. Then finish the outside, chamfer etc. and part off.
If you purchase a bushing with a tight center hole, a lathe is still the easiest way to ream the center, before installing the bushing. hth
This post was edited by russb wa at 21:41:58 02/01/13 2 times.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters