|Ford 9N, 2N & 8N Discussion Forum|
Re: Oil Pressure
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
|JohnKamerer said: (quoted from post at 16:39:38 01/10/13) |
|John Kamerer said: (quoted from post at 09:57:03 01/10/13) Thanks, that's reassuring . I'm still going through a few steps to fix it. The previous owner had the oil line at the bottom of the filter going into the valve adjusting side plate to spray the lifters. I'm thinking that enough oil stayed up on that ledge to cause low oil level in the pan. It's a thought. I'm rerouting the line today to the block to,test and then I'll run it to the govener. Let everybody know the results|
It is such a great help to get all that knowledge laying out there in the world of Internet .
Got the oil line ran to the govenor. Started up with 30 lbs of oil pressure. after 10 minutes went down to 15 and the after 15 min droped to 10. 20 mins it was down to 5. Rev it up to half throttle and it raised to 15. did this a few times. And then at idle would show 2-3 lbs. Rev it and it would come back to 10-15 Lbs. So, whats the thoughts out there?
This post was edited by JohnKamerer at 16:03:36 01/10/13 2 times.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters