A few years ago I read on this board about a basket someone rigged up that hooked onto the front grill and would hold a couple of milk crates.
My buddy is itching to try out his new welder and asked me if I had a project for him. (Aren't friends wonderful?)
Below is a picture I saved from a few years ago. I can't tell if the bottom is made out of angle iron (bed frame?) or just flat iron. My friend said he could use a steel mesh for the bottom, supported by cross pieces of flat iron.
Other than trying to figure out the best way to do the bottom, I think he's got it figured out. I just need to get the measurements to him.
Thanks for any suggestions or pics for other ways to do this.
Ken
My buddy is itching to try out his new welder and asked me if I had a project for him. (Aren't friends wonderful?)
Below is a picture I saved from a few years ago. I can't tell if the bottom is made out of angle iron (bed frame?) or just flat iron. My friend said he could use a steel mesh for the bottom, supported by cross pieces of flat iron.
Other than trying to figure out the best way to do the bottom, I think he's got it figured out. I just need to get the measurements to him.
Thanks for any suggestions or pics for other ways to do this.
Ken