any time you break a tire down.. sand or wire wheel the rim clean.. then paint with a rust control primer and then a piant.. like rustoleum, por.. or even an epoxy paint like appliance epoxy. it's VERY tough.. and prevents water getting in.. no water.. no rust.
if rims were loaded with salt wter.. wash them off well.. THEN clean.. then dry and paint...
Re: Re:Tire dismounting in reply to soundguy, 11-15-2012 16:38:21
The rims I did today, I bought for the turf tires on them. The PO said they were only 3 or 4 years old. They were on 28x12 rims, john deere according to him. The new (then ) rims were rusted to the tubes after such a short time. Paint is always my style, you can bet on several coats inside my rims, great way to use up extra paint. Who is going to see what color the inside is? Thanks for the reply, joe
Re: Re:Tire dismounting in reply to old-9, 11-15-2012 17:59:39
I had some rust control primer in brown i used on mylast set.. and some appliance epoxy white and black leftover from some other products.. I don't keep the epoxy paint long after opening as it goes bad.. so it was a good use.. who cares if one rim is black and the other white inside.. :)
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.