If you are 110% positive it has a sleeve TOH can make you a puck to remove it... If it were me it would go to a machine shop and have them bored it out to be on the safe side... How sure are you it has a sleeve....
Re: 8N .060 pistons in reply to Hobo,NC, 11-04-2012 18:44:09
100% It has thick sleeves that have been bored for .060 pistons which would leave about .060 thick sleeves.I will either try the weld method or have TOH make a new bushing. I'm leaning towards the weld method as I may never use a .060 bushing again.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.