As Del stated, the lower hinges and top locking tabs are different. My biggest problem was reshaping the angle of the grill to match the angle it required to fit between the two dog legs. The bottom solid pc of tin wasn't difficult to reshape, all the grill rods were. I cut them loose, reshaped at the right angle and migged them back so when the grill was snapped in the sides, bottom and top sections all matched the dog legs, hood and bottom hinges section.
Re: 8n gill on 9n tractor in reply to Flatlanderfool, 10-28-2012 18:43:49
. I am having a hard time installing my grill. Part of my problem is that my dog legs are both rusted bad. Could some post up or email me a close up picture of is area. And maybe one of how the top tabs attach. Thank you
Re: 8n gill on 9n tractor in reply to Petey156, 10-28-2012 18:48:31
Are you trying to install a 8N original grill or an after market 8N grill on a 9N? Here is a picture of the lower part of a '43' 2N dogleg. Is this what you were looking for? The hole at the bottom of the dogleg is where the grill should bolt to the dogleg. It takes a 5/16 fine thread bolt 3/4 inch long.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.