|
| |
| Ford 9N, 2N & 8N Discussion Forum |
Topic: Rear seals on 8N
[Return to Forum]
| Author |
[Modern View]
|
| CharnerL
08-14-2012 14:13:13
66.175.152.140
|
I bought an 8N about a week ago. The rear hubs were caked with old grease hard as clay. After cleaning it up and removing all components I am replacing the shoes and seals. The seals that came out were about 1/2" thick and the only ones found locally are about 1/4-3/8" thick. The ones on the internet do not list the thickness. Is the thinner seal a replacement? I would hate to assemble this rear end and have the same leakage using the thin seal. Any info would be appreciated.
|
|
|
|
| HCooke
08-14-2012 18:10:30
70.195.65.49
|
|
Re: Rear seals on 8N in reply to CharnerL, 08-14-2012 14:13:13
|
|
| Check out this site for a good primer on how to do that job.
|
|
|
| ZANE
08-14-2012 14:34:35
98.83.99.232
|
|
Re: Rear seals on 8N in reply to CharnerL, 08-14-2012 14:13:13
|
|
| | If it has the inner seal in the trumpet housing it also has a large seal on the mounting flange that should be replaced. If the hub is loose on the outer spline it will leak after new seals are installed. Zane
|
|
|
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
