|
| |
| Ford 9N, 2N & 8N Discussion Forum |
Topic: OT; Massey F 35 Torque/bolt
[Return to Forum]
| Author |
[Modern View]
|
| davidrz
08-12-2012 12:46:37
216.183.60.107
|
Have never had the following problem with my old Ford tractors.Helping a friend put back the cylinder head on an MF 35 (had the head redone). However, I noticed it is not possible to get the torque wrench on the four bolts/nuts which are located on the lowerside of the head. Is there a special wrench that attaches to the torque wrench????? Want to make sure it is torqued correctly since he had to take it off once since it was leaking water into the oil. The four bolts I mentioned seemed not to be as tight when we took it off. Thanks in advance for your assistance. David
|
|
[Reply] [No Email] | |
| Ultradog MN
08-13-2012 13:36:48
70.56.167.233
|
|
| Try asking your question on the Massey Board.
Lots of good folks there just like here.
|
[Reply] [No Email] | |
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
