1949 8N. New set of BLUE STREAK points. Whenever I tighten hold-down screws (mostly the screw below the points) gap becomes too tight (real tight). I don't notice play in the shaft so I don't think bearing worn. Old points were cheapee TSC ones and were a snap to get in and set year ago. These new ones were a bear to get installed. What am I doing wrong? Also, had to "farmerize" new copper condensor strap from old set of points as existing strap was only attached by a micron of copper, but I don't think this is why point gap is difficult to set...or izzit?
Dukester
Dukester