This genny and VReg are on that little forklift I bought.
The generator is a two brush type, two terminals on the barrel
and the ARM terminal on the end. No Hi/Lo adjuster.
It isn't charging at the battery and is not easily accessible to motor test.
I will take the ARM wire off and measure the output of the genny
itself tomorrow when I'm out there, didn't get to do that today.
I'm questioning if the genny and VReg are matched as far as A
or B circuit. The engine is 8N but the VReg seems to be later?
The generator is a two brush type, two terminals on the barrel
and the ARM terminal on the end. No Hi/Lo adjuster.
It isn't charging at the battery and is not easily accessible to motor test.
I will take the ARM wire off and measure the output of the genny
itself tomorrow when I'm out there, didn't get to do that today.
I'm questioning if the genny and VReg are matched as far as A
or B circuit. The engine is 8N but the VReg seems to be later?