(800) 853-2651
SHOP NOW

TX33 carb Extra hole

K

KirkWest14

Member
While I"m waiting for my block to get boiled out I started on the card today. The attached photo shows an extra hole in the lower body. All the photos I've seen son't show this as a hole or an extra plug. Any advise from the experts would be greatly appreciated. Thanks in advance.
 
(quoted from post at 14:53:54 10/23/17) While I"m waiting for my block to get boiled out I started on the card today. The attached photo shows an extra hole in the lower body. All the photos I've seen son't show this as a hole or an extra plug. Any advise from the experts would be greatly appreciated. Thanks in advance.
Click to expand...
see no photo
 
Pic didn't go through
a176166.jpg
 
The smaller hole on right should have some horse hair or the like in there to allow gas from flooding to drain out but keep dirt from being sucked in. Later units used a porous brass (sintered) plug there, performing same function.
 

Brought another N last week end had to take the carb off and clean it. I had a bottle of Mean Green sitting around so WTF put the carb in it dirty as ell caked in grease ETC to my surprise it cleaned the ell out of it. I did not get back to it till 8PM last nite I needed the bay today it was setting in so thu the carb back together it ran great idles great but likes choke every time you start it even hot. With the idle mixer screw ran all the way in it does not effect it. I got a place for it cleaned out in my other shop today so gonna take the carb back off and clean the idle circuit good and confirm it has the correct jet... The governor don't work gonna look at it, its a decent tractor needs some tinkering I am not going to spend much more time on it short sale it and move on...

It has a nice set of Goodyear 13.6's on it they need to go on my 3000... Anyone need a project $1000 may get it...
 
You must log in or register to reply here.

Similar threads

M
Question About Carb Rebuild
Replies
5
Views
761
Btzj02
Btzj02
L
TSX33 Carb restoration question - weird? drainage hole.
Replies
9
Views
2K
LarryMaine
L
M
172 Gas 4 cyl - general advice and cylinder bore specs?
Replies
9
Views
928
Maine4140HD
M
M
USX 37 Carb... 1850 Oliver / 4020 JD ... pictures
Replies
10
Views
868
Mike M
M
S
Ford 3000 - no 3 point hydraulics
Replies
4
Views
650
supton
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top