operationnos
New User
Good morning all, long time lurker here who finally hit an issue that I couldn't resolve by just browsing the old posts.
I have a 1949 8N with the 12v conversion. It was starting just fine until about a week ago and now I just get a click at the solenoid. Price was right so I just tossed on another solenoid (Tisco #8N11450) but I'm still getting the same issue.
It needed a new battery and cables so I put those on today but still having the same problem. I tested the volts on the right post of the solenoid and it's at 12.8v, the left post and the starter post while pressing the ignition (push button with key, yes, I'm always out of gear Dell) is just over 6v. Still, just a clicking sound.
I believe my wiring is solid (replaced connectors) and the ground location measures well... any advice would be appreciated.
I have a 1949 8N with the 12v conversion. It was starting just fine until about a week ago and now I just get a click at the solenoid. Price was right so I just tossed on another solenoid (Tisco #8N11450) but I'm still getting the same issue.
It needed a new battery and cables so I put those on today but still having the same problem. I tested the volts on the right post of the solenoid and it's at 12.8v, the left post and the starter post while pressing the ignition (push button with key, yes, I'm always out of gear Dell) is just over 6v. Still, just a clicking sound.
I believe my wiring is solid (replaced connectors) and the ground location measures well... any advice would be appreciated.