Hi all. The tractor in question is a Case 1490. Issue is the steering motor sits right below the steering wheel and it leaks fluid right on my shoes. It's getting annoying and rather slippery. I did post on the Case forum BTW. Fellow over there said it could be a seal in the orbit motor? Been thirty years since he done one. Would have to pull the dash probably but doesn't look to bad to get to. These motors sell for around $500 new aftermarket. I have been reading a lot and it seems many modern tractors use steering motors so was wondering if it is a DYI project to rebuild a steering motor in general or does one take it off and take to a hydraulic shop, or replace new?