Ironweld69
New User
I have a 1971 ford 3000 tractor the injection line started leaking so I ordered a new injection line set I'm not sure that I got the right one they are marked by the cylinder with the number two cylinder be in the middle
- Thread starter Ironweld69
- Start date
Ironweld69
New User
I wanted to know if the number two cylinder is in the middle of the motor it's a three cylinder tractor
Ironweld69
New User
The injection line that I got is close but it will have to be bent a little bit is this normal
Dune Country
Well-known Member
yes #2 would be in the middle, can be bent (slightly) if careful
Ultradog MN
Well-known Member
- Location
- Twin Cities
It won't hurt to bend those lines.
I had a 4000 that someone had cobbled the
lines a Lot.
I ran it that way for a while till I found
a set of used lines for it.
Yes, #2 cyl is in the middle.
I had a 4000 that someone had cobbled the
lines a Lot.
I ran it that way for a while till I found
a set of used lines for it.
Yes, #2 cyl is in the middle.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy