(800) 853-2651
SHOP NOW

UTS hydraulics

D

dfarmann

Member
An off the wall hydraulic question.

Im primarily a cow calf farmer and chop and bag corn silage for winter feed. Being I getting up in years it gets to be a VERY long day climbing on and off tractors all day feeding the bagger, and sure would be nice to use one of my UTs instead of a 6420 Deere.

My question is. Would a UT hydraulic system run a orbital motor that I would use to run the PTO of the Forage boxes to feed the bagger. One step up to the platform and go would save lots of miles on my carcass at the end of a day.

Basicly looking for Hydraulic live PTO for a UTS.

Please be specific with any other ideas.

Many Thanks.
 
You have two issues running hyd motors with open center systems. 1. Will the pump generate enough flow x volume to do job? 2. Heat build up. Used to use a 520 JD or IH 350 to run auger on fert wagon. Oil had an hour or so to cool between fills. If oil gets too hot it will cavitate as pump will lose prime. Good way to get moisture out of oil though!
 
A "U" hydraulic system not strong enough to run a orbit motor. A "U" was built before orbit motors came in to being. Your simplest solution might be to find a Char-lyn PTO pump and valve unit. There are some around.
MMDEL
 
You must log in or register to reply here.

Similar threads

K
Installing PTO hydraulic pump vs tapping into rear lift pump
Replies
5
Views
379
BarnyardEngineering
BarnyardEngineering
jon f mn
Cattle feeding questions
Replies
5
Views
438
RedGreenGuy
R
R
Farmall 504 PTO always on
Replies
13
Views
338
Janicholson
Janicholson
K
Farmall H hydraulics
Replies
13
Views
897
DeltaRed
D
E
Random hydraulic questions
Replies
2
Views
424
eod4647
E
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top