(800) 853-2651
SHOP NOW

MM UB

R

rmf1066

Member
It's me again with more questions about my UB. It's getting close to fire up and there is a couple of things that I'm having a hard time figuring out. First there are two lines on the left side of the block one that goes to the oil pressure gauge and the other one on a rectangular plate that I don't know where it goes or does. The other question is the tractors hyd pump was missing when I got it all it had was the spacer between the dis and pump with a oil line going to it. Can I take the spacer off and block off the line or do I need to put a cover on the spacer and keep the line. Thanks Ryan
a150575.jpg

a150577.jpg
 
the line from the block should be the oil pressure guage line. the other can be plugged ( in the cap). Put a plate over the hydraulic pump hole and keep the oil line. It puts oil onto the parts that runs your distributor. Not good if they are dry
 
The line in pic 1 on the plate is a vent/breather line goes to the top of the hyd reservoir under the front of the fuel tank,the other one I would personally plate where it is at and leave that line,just my opinion.
 
Thanks for all the help. This tractor was in pices when I picked it up and my first Moline. Thanks for all the help again!!! Ryan
 
You must log in or register to reply here.

Similar threads

B
Decal Placement for UB Special
Replies
10
Views
328
Alan K
A
S
UB Diesel
Replies
2
Views
681
Dieseltech
D
B
UB Special gas engine
Replies
15
Views
1K
sam c
S
E
Chevy/GMC tailgate Random Drop
Replies
13
Views
809
VicS
V
R
UB coolant issue
Replies
4
Views
724
Rich'sToys
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top