(800) 853-2651
SHOP NOW

heads, ranking better to worse for pulling

A

Anonymous-0

Well-known Member
does anyone have a list or something naming the compression ratios for mm heads? like 10a4232 thru 10a4206. thanks
 
That really depends on the type of puller you're building. No one head will be the best for all combinations. What are you wanting to build?
 
I replaced th heads on my M602 -336 CI Gas Burner engine from 10A4209 to 10A4210 because my old ones leaked and these new-old stock were available.

The compression is suspose to be 8.0-1 now instead of 6.5-1 and engine seems to start & run fine. How much have I increased the horsepower compared to what it was???
cleddy
 
You must log in or register to reply here.

Similar threads

P
Minneapolis moline big mo400 tie rod ends
Replies
10
Views
337
porkchop89
P
G
Help, specifications/Measurements for three-point hydraulic cylinder?
Replies
1
Views
183
used red MN
U
L
Quick Question - Should I Use Lock Washers on Flywheel Bolts?
Replies
2
Views
178
LarryMaine
L
N
5 Star rear main seal
Replies
3
Views
603
Caseboy1
C
T
MM Canadian UTS - Date of Mfg?
Replies
12
Views
510
tirediron
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top