(800) 853-2651
SHOP NOW

jet star steering

C

century farmer plus

New User

Hi folks,
I have enjoyed reeding this forum for years
and wondered if some one can help me out. One
of our jet star tractors (brown 61-62) the weld
broke on the shaft that goes through the bearing
cage assembly and then theres a heavy metal plate
the inner tie rods attach to. I have an IT manual and it looks much like fig. MM612-335 but
not exactly, paragraph 15 page 10. I have removed
the snap ring from the top, my question is can
I use a pulley puller to remove the sttering sector? I need to get this shaft out so I can weld it strong back on the bottom plate. Also
can anyone tell me which lines go where on the
power steering valve on this tractor? PS hasn't
worked in years and I may have some thing crossed. thanks for your help.
jim
 
There is a bearing on top of the selector gear that needs to be pulled first. Then the gear could be pulled off. My steering controller is like the m5. This type has 4 lines out the side. Top left goes to the front left. Top right goes to the right side. The bottoms are marked on the bottom side. Front bottom (in)comes from the pump. The bottom right (out) returns to the resvior. Hope this helps.
 
thanks ksmms for your reply,
there is no bearing on the top of this assembly,
just a snap ring
there is a key in the top gear (steering sector?)
can I remove this with a puller I dont want to break this part and really be up a creek.
thanks again
jim
 
Look on the bottom of the control valve, Some of them say 'in' and 'out' on them. That should get the flow from pump and to reservoir straightened out.

Also, the actuator pin may be worn out. it runs in a slot in the steering shaft behind the valve and is a tight fit in the shaft. A few thousands wear makes the power assist nonexistent.
 
You must log in or register to reply here.

Similar threads

J
MM Jet star pto clutch shaft removal need help puller
Replies
4
Views
193
JOCCO
J
T
Leaking Radiator on my Jet Star
Replies
9
Views
975
TCPDRETIRED218
T
F
5 star questions
Replies
4
Views
556
Ill John
I
T
Wireing diagram 1964 Jet Star to convert to a 12 volt ne
Replies
7
Views
559
TCPDRETIRED218
T
W
MM Jet Star 3 Super
2
Replies
22
Views
3K
Walkinfuss
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top