Early TO35 Hydraulics

DCA · Oct 1, 2008

The early TO35 used a 2 1/2 inch hydraulic lift cylinder. The piston is readily available, but the cylinder is not. Is there any reason that I can't just change to the 3 inch cylinder assembly used on the later models?

I am also looking for Position Control Link Assembly. It is no longer available from Agco, but I found mention of U&T Tractor Hydraulics Industries else where on this forum. Their web site has several parts for MH hydraulic systems that are not available on any other site that I have searched. Does anyone know anything about this company or where to order their parts?

Paul in AZ · Oct 4, 2008

Talk to Danny or Johnny at Mac Tractor parts. They can fix you up with a new 3" cylinder and rings along with a good used position control link assembly. 1-800-882-4742. They did the same for my TO-35.

DCA · Oct 5, 2008

Thanks for the response, Paul. The 3" cylinder, rings and piston are readily available. From everything I have researched it appeared that PN 184442M1 can be used, but I was looking for the confirmation that you supplied.

The bolts on the 2-1/2" cylinder are 7/16". The YT replacement for the 3" cylinder notes that the cover will have to be re-drilled for 9/16". Did you have to re-drill?

Do you happen to know if the control spring, plunger and seat from the newer models can be substituted for the same from the older models?

Early TO35 Hydraulics

DCA

New User

Paul in AZ

Member

DCA

New User

Similar threads