KCTractors
Member
- Location
- Central Wi
What is the secret for removing the imput shaft on MH-50. I can get it out about 1/4" and will not come out any farther. I want to change both shaft seals ( PTO and Trans). Any help is appreciated.
- Thread starter KCTractors
- Start date
miner09
Well-known Member
- Location
- Pattonville Texas
Take the bottom plate off(below shaft) and take snap ring off and let gear drop down so the shaft and assembly will come out. Look at manual and or go to Agco Parts Book online and you see the breakdown of parts.
KCTractors
Member
- Location
- Central Wi
miner09, Do I have to take the brake shaft out of the case before removing the cap for the lower shaft?
miner09
Well-known Member
- Location
- Pattonville Texas
Yes remove shaft.
John Deere D
Well-known Member
Photo from a Massey Ferguson service manual
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy