I lost the round ball on the end of a 3 point arm. The ball that is attached to your implement when using the 3 pt.
I purchased a two pack yesterday with new clips. I installed the new one with a new clip. Good thing I got the two pack.
When I got done disking stalks today, with a transport disk, the new ball was gone. The new clip was still in place.
Any suggestions? Short of putting something like wire through the ball when the 3 pt. is not in use. I'm assuming its wore and not a tight enough fit for the ball to stay in place.
I purchased a two pack yesterday with new clips. I installed the new one with a new clip. Good thing I got the two pack.
When I got done disking stalks today, with a transport disk, the new ball was gone. The new clip was still in place.
Any suggestions? Short of putting something like wire through the ball when the 3 pt. is not in use. I'm assuming its wore and not a tight enough fit for the ball to stay in place.