(800) 853-2651
SHOP NOW

699 update Masseynut(Australia)

A

Anonymous-0

Well-known Member
We put the front end back on the 699. It continues to work intermittently. My next step is to check the solenoid valve. I got a "T" so I can monitor the pressure from the solenoid valve. I am wondering if the issue could be in the coil, I have seen intermittent coils before. My theory is the solenoid works until the coil warms up and then it fails open.
Anyway the loader is now off the tractor and on the round baler so I need to find a time the tractor can be down. I plan to remove the plate below the operators feet to get to the solenoid. Paul
 
Solenoid failure sounds feasible. The gauge "T"eed in is the way to go. It will let you monitor what's happening with oil supply to the pack. You can then determine if your drive disengages at the same time as a possible pressure loss.If you have a loss of pressure, you could blank off the pipe supplying the pack, and then read off the pressure. This will tell you if the pressure loss is within the clutch pack when it warms up also.
I'm not sure if I asked before, has the IPTO been dropping out as well?
Let us know what you find,
Evan.
 
You must log in or register to reply here.

Similar threads

P
9n rebuild problems
2 3
Replies
51
Views
2K
Hobo,NC
Hobo,NC
P
300 u 6 to 12 v conversion update problem
2
Replies
28
Views
924
Paul 300 U
P
glennster
ignition coil update
Replies
7
Views
1K
mEl
mEl
J
NEED HELP: Ford 601 Workmaster won't start
Replies
15
Views
2K
showcrop
showcrop
F
New to me Ford 6610
Replies
17
Views
2K
Destroked 450
Destroked 450
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top