(800) 853-2651
SHOP NOW

massey 165 clutch replace

S

silversigns

New User
Hello to all I ma new to the forum I am splitting my massey 165 to replace the clutch.I have split tractors before not much trouble just time and patience. My question is the third special tool required for the job in the service manual figure 201I have no idea what this is for I have never done a dual clutch so not knowing what this tool is for scares me.Should I replace both seals while I am in there the real seal is leaking a bit as well as the front I am trying to keep costs down, but still doing it right.Any help on this or any tips would be greatly appreciated thnx.Just thought of this when I pulled the inspection plate off a pin fell out that was inside had a half moon head on it and what I think is the Belleville washer looks crooked and out of place.
 
not sure about the tool # you referred to I believe it's a tool to adjust the release finger adjustment bolts to the correct height,i've installed them without using one several times with no problems,just make sure they are adjusted level to each other once installed,as for seals if there leaking now the time to replace them,also if I make no mistake there is a freeze plug behind the flywheel that seals the camshaft I've seen them leak and not be the rear main seal,also the cork seal between rear main seal housing and oil pan can do the same,if it's hyd fluid the seals on the input shafts could be the problem ,you need a tool to replace them or risk damage to the seal,be sure to align the clutch disc correctly so input shafts go in and can be lined up with splines, guide studs make rejoining the engine easier UNDER NO CIRCUMSTANCES USE BOLTS TO DRAW THE HALVES TOGETHER serious damage will occur to the pto plate,your manual should refer to the use of three 1/4" studs used to hold pressure plate in released position during R&R, should also explain how to adjust 3 pto plate release bolts once it's installed on flywheel
 
You must log in or register to reply here.

Similar threads

P
Massey 165 question about engine sump
Replies
5
Views
271
PEI Massey165
P
M
Massey Ferguson 203 Workbull Industrial, need clutch replacement parts help.
Replies
11
Views
439
Stan Coryell
S
T
Joining 2510 after split
Replies
10
Views
727
TXTN JD
T
M
Power beyond on my Massey Ferguson MF50A?
Replies
0
Views
79
Mysteree11
M
A
165 and 175 brakes
Replies
4
Views
543
anderson farms
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top