I posted this on the repair forum, but i figured I
would also put on Massey forum.
I just replaced the piston pin bushing doing a
rebuild on a MF285 (Perkins A4.318) and had to hone
out > 0.040" to get the new pins to fit. I noticed
that portions are honed past the brass colored
surface.
Are these bi-metal bushings? If so, do I have a
problem?
Thanks
would also put on Massey forum.
I just replaced the piston pin bushing doing a
rebuild on a MF285 (Perkins A4.318) and had to hone
out > 0.040" to get the new pins to fit. I noticed
that portions are honed past the brass colored
surface.
Are these bi-metal bushings? If so, do I have a
problem?
Thanks