(800) 853-2651
SHOP NOW

mf 40 industrial ROPS

M

mf40inme

Member
Hello, I have an MF40 industrial that I would like to fit an ROPS structure to. Quite honestly, more for the sun/rain shade and a place to mount lights, than the actual protection.... however I was curious if anyone had plans to build one. I am a pretty good welder and was planning on building my own, based on the picture in the link below, however I have seen what seems to be the same thing on more than a few tractors, curious if it was offered by someone. I'm sure that it will be more expensive than I am willing to spend, but maybe not. Either way, dimensional drawings would make fabbing it up far easier.

thanks in advance

http://www.external_link/industrial-tractors/000/1/3/138-massey-ferguson-40-photos.html
 
I made 1 for my 205 industrial and just made it about a foot higher than the top of my head when sitting in the seat. I used 2" square tubing because I only wanted it so I could put a canopy on to keep the sun off my old head. Maybe I can get a pic of it if you want to see it.
 
My Mf40 already have the pockets for the ROPS. Just place 2in square tubing in there and figure out what you need for head room, connect them with a box and you are done. I will do mine this summer if I keep it.
 
Damn, mine doesn't. I work on a ship, and consequently have access to stick, mig and tig welders, sadly not at home though. I do have a stick welder, but no torch or a real good bench to fab stuff on.

I just made the pieces to mount the square tubing to the side of my loader, and will do just what you say. It would be nice to have the actual plans.

Anyhow, thanks every one for the help
 
You must log in or register to reply here.

Similar threads

A
Hydraulic plumbing question, MF 40 Industrial, MF52 back
Replies
2
Views
380
akwells
A
L
Farmall/International Super A Industrial
Replies
3
Views
331
Jim Becker
J
A
Tachometer for MF 40 Industrial
Replies
0
Views
467
akwells
A
S
MF 40 Industrial 3 point hitch
Replies
4
Views
1K
stoughtonfarmboy
S
B
MF50 and 65 Front Axle-Spindles vs MF Industrial Tractor
Replies
3
Views
995
Bill VA
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top