|
| |
| Massey Harris & Massey Ferguson Tractors Discussion Forum |
Topic: Re: Thermostat removal, MF165
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| Dieseltech
02-19-2013 20:46:29
199.16.223.2
|
When tractor was shut down to check the oil injection pump metering valve may have stuck in the off position. If you can get it started again you may help free it up this way. Disconnect stop cable from lever at pump so you can work lever by hand. Start engine and set hand throttle for 1800-2000 rpm. Now slowly move stop lever toward off to about 1500, then back on quickly. Do not turn off completely as it may stick again. Repeat several times until speed picks up quickly when lever is turned on again after being shut off. I have gotten some freed up this way in the past. Have also had to completely clean and reseal some too. Just mailed out a 135 pump that had the same trouble. Good Luck, Rich.
|
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
