(800) 853-2651
SHOP NOW

MH 33 hydraulics hookup to pull type disc

R

rklink

New User
Recently bought a pull type disc with hyd assist.
I need to know which ports to use off of the
hydraulic cylinder. There is one "on top" and
looks like two coming off the left side,
horizontally.
My dad had a hookup to raise/lower a combine
platform, but I can"t remember which ports were
used. So which ports are used in such a case?

Also, I bought some quick connects, to use, but
the male end of the hose goes into the qc with
great difficulty. Do I need to replace the male
ends of the hose with the ones that came with the
QC, or should they "just work"?
 
The quick connects will be difficult to connect if there is hydraulic pressure in the hoses. On an older tractor it's best to shut down the engine and hold the control lever in each direction for a few seconds to bleed off the pressure before disconnecting.

If there is no pressure then change out the male ends with the new ones. It will only take a couple of minutes.
 
On my 33, I tapped into the ports on the side of the cylinder control, and that worked just fine for me, BUT.. I have saw where guys have used the "top" port, and one on the side.. I don't know that there is a "right" way.. I can take a picture of mine and post it, if you'd like..

As for the hoses being hard to hook up, you will have that when they are under pressure...

BUT... A friend of mine is a parts man for a C-IH dealer, and he now buys female fittings that are easy to connect under pressure.. They are a bit pricey, but after seeing how they work, I'm going to invest in a couple sets of them.. I can try to get you a part number if you'd like also.

Brad
 
thanks for the info.
hopefully my problem is just pressure.
It"ll take me a while to try this out again.

I would be interested in that part number.
 
You must log in or register to reply here.

Similar threads

C
MF Power Steering
Replies
1
Views
518
Mduncan60
M
F
1210 hydraulic remotes question
Replies
1
Views
238
RGMartin
R
C
Bush hog 3pt to Pull type conversion
Replies
18
Views
4K
BarnyardEngineering
BarnyardEngineering
O
Case 1175 hydraulic pressure won't lift disc
Replies
9
Views
489
Old Mexico tractors
O
B
IH Fast Hitch Plow and Disc ID
Replies
7
Views
782
Kevin Happke
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top