| Massey Harris & Massey Ferguson Tractors Discussion Forum |
Topic: Continental Hd 277 Question!
[Return to Forum]
| Author |
[Modern View]
|
| Dennis Kerr
12-18-2012 19:15:09
24.154.224.152
|
How far should the intake valves be recessed into the head on a Continental HD 277 four cylinder motor? Thank you,
Dennis Kerr
|
|
|
| Mike in Mn.
12-19-2012 07:36:15
74.37.53.37
|
|
Re: Continental Hd 277 Question! in reply to Dennis Kerr, 12-18-2012 19:15:09
|
|
| Not real sure what you are asking, The intakes are fairly flat and set down fairly tight in the seats, but should not be down below the surface. The exhaust valves do set up in the combustion chambers quite a bit higher than the intakes. Depending on what you are using the tractor for, if you can get a good seat or seal it should run ok, or else get new seats installed. I just noticed you have a diesel head, I'm talking a gas engine, haven't had a 277 diesel apart in a long time.
|
|
|
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
