Author	[Modern View]
samn40 10-07-2012 17:41:33 81.135.25.67 Report to Moderator	It only needs to move a little to work, but there are complicated settings in there that require special tools so be careful!. Some of the I&T manuals give instructions on how to make the tools and also give the settings. By the way are you sure you needed a pump? sometimes a stuck control valve is the problem if the pump completely refuses to work.Even a well worn pump will operate the linkage but maybe not lift a heavy implement. Also the draft lever has to be fully in the up position for the position to work and the position has to be near the up position for the draft lever to work. Sam [Reply]   [No Email]
josh8906 10-07-2012 18:31:19 72.152.17.167 Report to Moderator	I have the I & T manual and set the linkages but the position control lever just don't feel right. The direction it moves doesn't seem though it is enough to move the control arm. I went ahead and replaced the pump because were somebody had the lift cover off before they broke the control arm off so it had been a very long time since the hydraulics worked and I didn't wont to take a chance when I got it back together that it didn't work properly.   [Reply]  [No Email]