David - just out of interest have you ever seen on of these shear tubes actually break? I worked for an MF dealer here in East Kent for 6 years, in that time I removed many of them for various reasons but as far as I can remember they were all in one piece. Ray.
Re: MF 65 Hydraulic Pump Rebuid in reply to Ray UK, 09-16-2012 14:39:36
Hello Ray, In my 40 years of MF experience I would have to say that I haven't actually seen one break either. I have had several where the splitpins have worn away, dropped out and disengaged though. It is there as a safety device but in saying that it only shows what the tube and transmission is capable of withstanding. You might have heard of the book Inside Massey Ferguson written by ex-MF Service Dept and Technical Author David Walker. Out of curiosity I will send him an email for his experience in this and post back. DavidP, South Wales
Re: MF 65 Hydraulic Pump Rebuid in reply to DavidP, South Wales, 09-17-2012 05:38:47
I got S.40843 installed but am unable to tighten the bolts and still have the shaft turn freely? The piston blocks will rock so I am pretty sure it is the brass blocks are binding. Is this normal and I should let the engine fix it? Or do I need to send it back? The middle fork moves just fine.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.