john deere 535 roll baler

rickymotorbrains · May 24, 2018

can anyone tell me why I aint running any pressure on gauge for tension its not rolling tight

chuck from neb · May 24, 2018

Check the tension springs ..maybe the coil is broke

rickymotorbrains · May 24, 2018

it useses the hydraulic pressure on for tension

430WLPG · May 24, 2018

Blown tension cylinder piston seal leaking internal and or rod seals , probably have to kit both since it would be luck guess as to which one

JD Seller · May 24, 2018

The first thing to do is close the door and hold the SCV lever and see if the gauge shows pressure while the tractor is pushing oil to the baler. If it is doing that then let the SCV lever go back to neutral. If the pressure drops right away try another SCV as the trouble could be in the tractor. IF another SCV acts the same then the trouble is in the baler. Like and earlier poster stated it would more than likely be a tension cylinder leaking internally. Just remove the cylinder and rebuild it.

Truthfully the majority of the time it is usually the tractor rather than the baler that causes the trouble.

Tx Jim · May 25, 2018

Ditto what JD Seller stated.

Read my reply referring to checking tension cylinder for internal leakage on your same question on Implement Alley.

john deere 535 roll baler

rickymotorbrains

Member

chuck from neb

Member

rickymotorbrains

Member

430WLPG

Member

JD Seller

Well-known Member

Tx Jim

Well-known Member

Similar threads