I recently bought a JD 8300 Grain Drill. It is in good shape but as you might think it was put up with grain still in it and was left out in the weather for who knows how long. I am in the process of soaking the chains , Shafts etc. with my favorite penetrating oil but not sure the best way to clean out the feed section.
I am planning on pressure washing as best as I can but then not sure which way to go. Manual says to use diesel fuel to soak down the workings when you store it but not sure this will do the job of freeing it up.
Also where beside Mother Deere is a good place to get parts? chains,seed tubes, bearings etc.
Any suggestions will be greatly appreciated.
I am planning on pressure washing as best as I can but then not sure which way to go. Manual says to use diesel fuel to soak down the workings when you store it but not sure this will do the job of freeing it up.
Also where beside Mother Deere is a good place to get parts? chains,seed tubes, bearings etc.
Any suggestions will be greatly appreciated.