2rich4me63
Member
I have a couple of JD shutters that I want to verify what they fit. Can someone point me to a sizing chart by outside dimensions or bolt hole center-to-center dimensions that would indicate what model the shutter fits?
- Thread starter 2rich4me63
- Start date
Mike(NEOhio)
Well-known Member
- Location
- Newbury, Ohio
H is 15 inches wide and 16 high not counting the flanges. Can't help with A dimensions just now but others may chime in.
you might contact Tim Sieren email- [email protected] He makes new repops.
Village Blacksmith
Member
I tried to find a picture, but one computer is down. Anyway these are the measurements for
an 'A' JD, used on a 1946 'A'.(and many other years).
Louvers----------17
Holes across top----14.5"
Total Width-----18 3/16"
Total Height----23 5/16"
Holes across bottom----14.0"
Top hole to bottom hole----22 5/8"
Hope this helps.
an 'A' JD, used on a 1946 'A'.(and many other years).
Louvers----------17
Holes across top----14.5"
Total Width-----18 3/16"
Total Height----23 5/16"
Holes across bottom----14.0"
Top hole to bottom hole----22 5/8"
Hope this helps.
Pete in MD
Well-known Member
- Location
- Central Maryland
From a note I put in my parts catalog when I put shutters on my '47 BO.
Bolt hole center-to-center dimensions for Unstyled B's and BO/BR's:
15-1/2" side to side
14-1/4" top to bottom
Bolt hole center-to-center dimensions for Unstyled B's and BO/BR's:
15-1/2" side to side
14-1/4" top to bottom
sunsettractor
Member
Styled D
Outside measurement
22 5/8" High
20 7/8" Wide
Mounting Hole Center To Center
15 1/8" Across, Top & Bottom
21 1/2" Top To Bottom, Both Sides
Outside measurement
22 5/8" High
20 7/8" Wide
Mounting Hole Center To Center
15 1/8" Across, Top & Bottom
21 1/2" Top To Bottom, Both Sides
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy