I had posted back a few months ago about finding my grandparents 4430 I was just updating that I finally got around to replacing the camshaft which I'm sure was original. I think I was on borrowed time because there were some teeth flaking off on the old one it wouldn't have run much longer. I replaced the oil pump gear also I'm sure it had been replaced at one time but the teeth were getting sharp again. I'm also going to roll all new bearings I and replace the rod bolts. The bearings were dated 1998 so I'm assuming it had been overhauled after my grandparents farm sale which was in 1995. It does start very good for a 4430 and so far doesn't seem to use any oil. I'm having the injection pump gone through currently and removing what was left of the mouse trap linkage and also having the injectors checked at the same time.
<image src="http://forums.yesterdaystractors.com/photos/mvphoto10858.jpg"/>
<image src="http://forums.yesterdaystractors.com/photos/mvphoto10858.jpg"/>