Rusty wheel
Well-known Member
Opinions wanted. Does a John Deere three point disc plow pull easier or harder than a three point mold board. Disc plow plows a ten inch furrow, Mold board is fourteen. Thanks.
- Thread starter Rusty wheel
- Start date
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
Disc plow of equal bottoms pulls easier than a moldboard because it cuts less width not to mention the rolling action of disc makes pulling easier. I spent many hrs in my youth driving a JD tractor pulling a 404 disc plow.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy