richard1949
New User
I have discovered that my 1949 Model G flywheel was installed 180 out at some time in the past. It
starts and runs fine. However the engine is out of balance and the tractor shakes noticeably. Can
I leave the flywheel as is and instead re-install the clutch driven plate (it is counterweighted)
180 out to correct the imbalance? I'd rather not get into the flywheel due to possible spline issue
that is currently "fixed". Thx, Richard
starts and runs fine. However the engine is out of balance and the tractor shakes noticeably. Can
I leave the flywheel as is and instead re-install the clutch driven plate (it is counterweighted)
180 out to correct the imbalance? I'd rather not get into the flywheel due to possible spline issue
that is currently "fixed". Thx, Richard