D&C Farm
Member
Will a 404 power unit engine with rotary pump fit in a 4010
- Thread starter D&C Farm
- Start date
buickanddeere
Well-known Member
Was the 4010 gas or diesel?
What is the casting number on the 404 block?
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
YES
coonie minnie
Well-known Member
Tim S is the expert on that one. If I'm not mistaken, the older ones with a vertical injection pump fit a little easier than the newer ones with the horizontal pump. I'm sure he will be along with an answer.
D&C Farm
Member
Thanks to all that replied
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy