(800) 853-2651
SHOP NOW

JD 2240 control shaft seals leaking

J

JoeG

Member
Hi Guys,
My early model 2240 has leaking load shaft seals and I am wondering if there is a better way to replace them than what my manual would have me believe. I have read some posts that make it sound pretty easy but when I look at the manual it has me remove the left final drive along with the rockshaft cover. Is there another way? The seals are installed from the inside correct? Any clarification is appreciated.
Joe
 

R&R of load control seals can be accomplished ""without removing"" final drive & rockshaft housing.

Drain trans oil,put L/D control under seat in "D",remove draft arms,tap shaft out of trans case,check bushings for excessive wear,R&R seals, reinstall shaft & 3pt draft arms shimming excess side to side motion out of shaft. While oil is drained would be a good time to check cleanliness of sump screen(parts key 15)
mvphoto18788.gif
 
Thank you for the help Jim. The seals were actually quite easy to replace compared with what was shown in the manual!
 
You must log in or register to reply here.

Similar threads

O
JD 620 transmission to powershaft seal
2
Replies
25
Views
824
J.Wondergem
J.Wondergem
B
4440 JD control shaft
Replies
2
Views
273
Tx Jim
Tx Jim
D
John Deere 2020 Load Shaft
Replies
14
Views
340
Fixingfarmer
Fixingfarmer
M
Ford 555 leaking out of the side of the trans
Replies
3
Views
210
MiMisfit
M
L
JD 2240 No Hydraulics
2
Replies
22
Views
936
ferlopesp
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top