J Bouchard
Member
Finally got around to trying to figure out why my 2010 forklift barely pulls itself around. The transmission is the H-L-R as opposed to the constant mesh type, essentially a 4 range with a reverser for foward and back. On the forklift I believe there is no HIgh low, just foward and back. Anyhow, am trying to figure how to adjust the clutch valve according to the service manuel,the picture shown is difficult to see, and the directions are difficult to understand , not sure how to adjust the clutch valve to obtain the 1/4 inch from the machined surface they refer to. Anybody understand this adjustment? It is the first step in the manuel for adjusting this clutch.
