morgan in ar
Member
I ordered the two long #53 and #40 drill bits to clean out passages on a dltx carb. It didn't take me long to break off the #40 one in the passage that goes down from the top of the carb next to the idle adjustment needle. (Yes, I was using it by hand.) Any ideas on getting it out? It is about 1/2" inside the passage. I've already tried tapping, heating, compressed air from the other side, and a grease gun with a needle tip. I had really high hopes for the grease gun. Carb is a DLTX 67 on an electric start B, if anybody has a rebuild-able one laying around. Any ideas would be greatly appreciated! Morgan