3020 drawbar support front pin removal

Anonymous-0 · Sep 18, 2013

Cannot get the pin to move. Manual says to drive pin out. Have soaked it with pb blaster, and tried to drive it out. Do not want to damage housing.

larryanderson · Sep 18, 2013

On the ones I have been around you have to line up the top of pin with slot and it pushes out no driving required.The slot is there to keep pin from coming[jumping] out .If it is actually froze then a little heat might help.I have never seen one froze but anything is possible.

Cliff Nelson · Sep 18, 2013

If you're talking about the horizontal pin that supports the front of the front drawbar support, it is a press fit. Drive it out with a good large diameter punch. I find that an air hammer with a straight punch works well. They can be tough to get out sometimes.

tim s · Sep 18, 2013

Yes they are tuff Cliff,, I have feared that I may break the housing hammering on them,, ...and that would turn "nasty"...

D- · Sep 18, 2013

Larry you're thinking about the wrong pin.
He said support front pin.

RC in NC · Sep 18, 2013

Thanks for the replies. I"ll try to see if it will come out.

larryanderson · Sep 18, 2013

I misread his question!

D- · Sep 19, 2013

I do that myself.

Marc G · Oct 19, 2013

I am attempting to replace the front drawbar support on a early model 3020. Has anyone replaced one of these?, and would like to share the procedure? I have the general concept down.
Any help would be greatly appreciated!

Marc G · Oct 25, 2013

I made a mistake! I am going to replace the front drawbar support on a John Deere 4010, not a 3020. Can anyone give any advise?? It would be greatly apprieciated!

3020 drawbar support front pin removal

Anonymous-0

Well-known Member

larryanderson

Well-known Member

Cliff Nelson

Well-known Member

tim s

Well-known Member

D-

Well-known Member

RC in NC

Member

larryanderson

Well-known Member

D-

Well-known Member

Marc G

New User

Marc G

New User

Similar threads