Author	[Modern View]
Tim S 02-10-2013 09:59:05 75.49.4.139 Report to Moderator	Keep in mind that the tooth count is different between gas and diesel flywheels,wondering if you starter guy is on the right page... [Reply]   [No Email]
matthies 02-10-2013 17:51:29 173.224.23.197 Report to Moderator	Re: 4020 keeps breaking gear off starter in reply to Tim S, 02-10-2013 09:59:05   But the drives are quite a bit different, armature shaft is half the size. chris [Reply]  [No Email]
Mike M 02-11-2013 06:32:16 24.140.0.120 Report to Moderator	Re: 4020 keeps breaking gear off starter in reply to matthies, 02-10-2013 17:51:29   FYI; I put a diesel starter that was converter to 12 volts on our GAS 4020 by just switching the drive. I think the armature shaft was larger back where the bushing goes but was not where the drive sets. Only reason I even tried this was because I had these parts laying around and didn't cost me anything. [Reply]  [No Email]
matthies 02-11-2013 20:03:18 173.224.23.197 Report to Moderator	Re: 4020 keeps breaking gear off starter in reply to Mike M, 02-11-2013 06:32:16   Thanks, the ones I've seen are quite a bit different, I was fighting a late 4020 LP once and couldn't find much to work with. chris [Reply]  [No Email]
Mike M 02-12-2013 05:39:20 24.140.0.120 Report to Moderator	Re: 4020 keeps breaking gear off starter in reply to matthies, 02-11-2013 20:03:18   Our 4020 gas is an early one 1965 ? and that 24 volt starter came off a early jd500 TLB (3020)tried the starter conversion on the 500 and I didn't like it. Didn't seem to turn over very good ? so I got a late 4020 D 12 volt starter for it. [Reply]  [No Email]
Tx Jim 02-10-2013 10:40:17 67.142.163.20 Report to Moderator	Re: 4020 keeps breaking gear off starter in reply to Tim S, 02-10-2013 09:59:05   IIRC the diesel starter gear has 10 teeth [Reply]  [No Email]