oil pressure gauge 3020

LITTLE RED · Feb 6, 2013

I want to put a oil press. gauge on this tractor don't trust idiot lights was going to plumb it into the sending unit and run both that looks very tight behind the breather pipe is there another spot i could use.

tim s · Feb 6, 2013

I know it"s tight there but that is the best place to hook in,,it"s actually a waste of time to plumb the light sender back in, but you can get a brass "Tee" to work there, and bring your gauge fitting out the side.

LITTLE RED · Feb 6, 2013

Tanks Tim i have all the tees etc just trying to get out of a difficult spot to work .

tim s · Feb 6, 2013

If you use a 2 or 3 inch nipple it brings you up out of the tight place enough to work, the allen plugs along the right side of the lower block lead to the cam bearings and you can pick up there, but they are usually to tuff to get out and they are kinda out in the open there,,the sender spot is where I end up..

oil pressure gauge 3020

LITTLE RED

Member

tim s

Well-known Member

LITTLE RED

Member

tim s

Well-known Member

Similar threads