(800) 853-2651
SHOP NOW

630 gas tank sediment bowl assembly

A

Anonymous-0

Well-known Member
I had the entire sediment bowl assembly off the tractor to put in the new rubber diaphragms. I now have a leak around the pipe threads from the tank to the sediment bowl assembly. I can not really tighten it because then it doesn't line up with the gas line and oil pressure lines. I tried liquid pipe seal and it leaked. Do you guys have any suggestions? Thanks, Denny
 
Use permetex # 1 I think that is the number for the hardening type of sealer. Let it set and cure for a day before refueling. Later if needed it will come apart without too much extra effort.
I always keep the hardening and non-hardening permetex sealers on hand.
 
Wrap the pipe treads with teflon tape make sure you wrap the tape so it follows the threaded direction of the assembly as you screw it in you really do not need it that tight to not leak keep checking your fuel line allignment as you screw it in so you dont have to back it of you may have to experiment a few times to get the right amount of tape on the threads and get a firm fit, good luck
 
I use some white stuff but can't remember the name or spelling of it. Anorobic (SP) or something like that. Made for fuels and oils. Works good. Got it at the hydraulic place.
 
You must log in or register to reply here.

Similar threads

O
630 fuel tank and wiring harness
Replies
4
Views
295
PJH
P
N
Gas Tank and Glass Bowl not filling
Replies
10
Views
562
NW-FLORIDA
N
B
Sediment bowl for starting engine fuel tank on 730D ?
Replies
11
Views
528
buickanddeere
B
Steve in IL
Oil Pressure Based Fuel Shutoff Sediment Bowl
Replies
3
Views
338
Steve in IL
Steve in IL
K
John Deere M
Replies
5
Views
416
apiarx
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top