Finally got the 2 stage clutch back together. Made an aligning tool from a dowel rod and layered masking tape. It fit through the pilot bearing and both clutch plates. Took forever and a day to get the two halves of the tractor aligned and all the splines. Had to jack up the rear tire so I could spin the inner shaft and get it to slide on the splines.
Problem was the fingers were set wrong. Probably didn't need a full split but I learned and she works now! 2 stage clutch!
Thanks
Problem was the fingers were set wrong. Probably didn't need a full split but I learned and she works now! 2 stage clutch!
Thanks