Author	[Modern View]
Tx Jim 12-08-2012 03:52:14 67.142.163.25 Report to Moderator	I would recommend checking pressures and the only test ports that are suppose to have pressure in 15th gear are C1,C2,BHi & B4. I would suspect that Clo may be getting some pressure and it isn't suppose to or possibly has some warped disc's. This post was edited by Tx Jim at 03:56:26 12/08/12. [Reply]   [No Email]
1963 12-08-2012 15:19:14 70.40.236.150 Report to Moderator	Re: 4850 trans? in reply to Tx Jim, 12-08-2012 03:52:14   It runs fine in 15th gear until you throttle down and then hit the throttle again. Loses about 3 mph and the engine seems to labor and in about 3-5 minutes the hyd oil temp light comes on along with the ? and eventually the stop alarm. [Reply]  [No Email]
Tim S 12-08-2012 16:18:30 68.75.23.93 Report to Moderator	Re: 4850 trans? in reply to 1963, 12-08-2012 15:19:14   It"s possible that low trans pressure is causing the alarm to go off,low pressure can cause a slow shift letting one clutch stay on a bit longer or one "not" engaging quick enough. warm it up and do some pressure checks to see what kind of trans pressure you have,,another possibility is a clutch can be warped and dragging too...B&D is right deal with it now and the cost may be minor...it will only get worse.... [Reply]  [No Email]
buickanddeere 12-08-2012 15:27:22 216.183.148.142 Report to Moderator	Re: 4850 trans? in reply to 1963, 12-08-2012 15:19:14   Don't keep operating the tractor in any gear. A moderate priced repair will be very expensive. [Reply]  [No Email]