(800) 853-2651
SHOP NOW

4020 drawbar support

R

ridgelane

Member
Hi

From reading the latest posts, looks like 4020's are under repair this fall.

I have replaced the bushings and seal in the front drawbar support on a late model 4020 and those on the load control shaft.

My support has a bolt in the back that butts up to the transmission housing. What is the proper way to adjust that bolt?

Thanks
 
You must log in or register to reply here.

Similar threads

B
4020 powershift slips going into 8th
Replies
17
Views
711
620 John
620 John
M
4020 Load Control Shaft Shimming Recommendations
Replies
5
Views
422
mtb34
M
R
4020 park cable
Replies
2
Views
422
Richard55
R
G
John Deere 4020 - PTO clutch adjustment
Replies
4
Views
461
Cliff Nelson
C
8
Pin and bushing front drawbar support
Replies
4
Views
561
8850dave
8
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top